How to Cluster Proxmox
Category : How-to
Clustering is a technique to group together multiple machines or devices providing common parameters, such as storage, over all machines in the cluster. Proxmox can be clustered to provide a common interface to control all machines in the cluster.
Automatic failover of machines can also be achieved with a Proxmox cluster however this requires significant setup and it not available out of the box. I will discuss VM failover in a future blog post.
Create a new Cluster
To join one or more nodes to a Proxmox cluster we must first create a cluster on one of the machines. Run the below command on your first Proxmox node and replace [CLUSTER_NAME] with a name for your cluster.
pvecm create [CLUSTER_NAME]
Check the status of a Cluster
Once a cluster is created, you can check the status using the status command.
You can use the nodes command to view all nodes in the cluster.
Add a new Node to the Cluster
Adding a new node to a Proxmox cluster is easy and only requires the hostname or IP address of the primary cluster node. It is highly recommended to use a hostname or DNS entry over an IP address to shield any IP address changes.
On a non-clustered node, log in and run the pvecm add command and specify the IP address or hostname. You can use the IP address or hostname of any already clustered Proxmox node.
pvecm add [HOSTNAME_OF_CLUSTER]
You must not have any virtual machines/ OpenVZ containers running on the node which you are adding to the cluster. All nodes should also be running the same component versions of Proxmox to ensure compatibility.
Leave a Reply to techdanger Cancel reply